25
ADJUSTABLE BED FRAME - OWNER’S MANUAL //
CLEANING
NOTICE
Cleaning agents, such as non-alcohol based cleaners, sanitizers, and others can destroy the
anodized layer of the Adjustable Bed Frame. Use only a dry or slightly damp lint-free cloth to
clean the Bed Frame
MAINTENANCE
The Adjustable Bed Frame does not require maintenance. If the Bed Frame becomes damaged,
RULI\RXDUHH[SHULHQFLQJWHFKQLFDOGLႈFXOWLHVFRQWDFW/2*,&'$7$XVLQJWKHGHWDLOVRQSDJH
7. CLEANING AND
MAINTENANCE
WARNING
Moderate risk of death or serious injury through electric shocks
Leaving the Bed Frame plugged in while cleaning it may lead to death or serious injury
through electric shocks.
• Use only a dry or slightly damp lint-free cloth to clean the Bed Frame
• Do not allow any of the Bed Frame’s components to become wet during cleaning
• Always unplug the Bed Frame from the mains before cleaning
To clean the Adjustable Bed Frame, use a dry or slightly damp lint-free cloth to wipe the Bed Frame.
26 //ADJUSTABLE BED FRAME - OWNER’S MANUAL
8. TROUBLESHOOTING
BEHAVIOR
The Bed Frame does not
respond when Buttons are
pressed.
Parts of the Bed Frame re-
main in an elevated posi-
tion after a power failure.
POSSIBLE CAUSE / SOLUTION
1. The Bed Frame is not connected properly. Check the power
connection
2. Time-out has been reached due to continuous operation. Do
not operate the Bed Frame for at least 6 minutes. This will re-
set the time-out.
3. Unplug the Power Converter. Wait until the LED goes out,
then plug it back in.
4. Replace the batteries in the Remote Control.
If power cannot be restored, an Emergency Lowering is required.
Proceed as follows:
1. Unplug the Power Converter from the power outlet.
2. Disconnect the Power Converter from the Cable Leading to
the Control Box.
3. Connect the Battery Strap to the Control Box Cable instead.
4. Connect two 9V batteries to the Battery Strap.
5. Use the Head DOWN/UP, Foot DOWN/UP or Sleeping Po-
sition Buttons to drive the Bed Frame to its lowest position.
Once Emergency Lowering is complete and power is restored,
you can reconnect the Power Converter. Then, perform a Ref-
erence Drive (see Chapter 5) and operate the Bed Frame as
normal.
27
ADJUSTABLE BED FRAME - OWNER’S MANUAL //
Parts of the Bed Frame do not
move evenly.
Make sure no persons or heavy objects are on the Bed
Frame or in the range of moving parts.
The Bed Frames may be misaligned. Follow the instruc-
tions in the section “Fixing Misalignment” to realign the
Bed Frames.
NOTICE
When an Emergency Lowering is performed, only the Bed Frame connected to the Battery Strap
will be operated. You will need to perform separate Emergency Lowerings for Bed Frames con-
nected by the Sync Cable.
CODE
2 X Click
1 X Click
4-6 X Click
DEFINITION
Normal operation. Continue to operate the Bed Frame.
The system is working in emergency operation mode. Contact
Customer support.
An internal error has occured. Contact customer support.
CLICK CODES
As soon as the Bed Frame is connected to the power outlet, the Control Box uses installed re-
lays (clicks) to inform the user about system status and the reason for the last shutdown. Codes
are only transmitted during system startup. Potential click codes are as follows:
