background image

INSTRUCTION SHEET NO.

IS:2025WH

A0203 Page 1 of 1

INSTALLATION OF LYTECASTER

®

REFLECTOR TRIM IN THE 2000LV/2004ICV SERIES 

FRAME-IN KITS WITH ROTO CLIPS

NOTE:

Installation and lamping procedures for the square and round
styles are the same as follows:

1. Frame-In (Fig. A)

See 

Frame-In Kit

Instruction Sheet for installation procedure.

For use with 2000LV/2004ICV series Frame-In Kits only.

2. Rotate Roto Clips (Fig. B)

As shown in Fig. E.

3. Prepare Socket Cup

Remove the 

Lamp Adjustment Mechanism

from the Socket

Cup by bending the the Tabs away (3 places), (see Fig. F & G).

4. Snap-On (Fig. C)

Insert Socket Cup into 

Housing

. Make sure 

Springs

of 

Socket

Cup

snap into 

Slots of Housing

Fig. C.

5. Push-in (Fig. D)

Push 

Housing Trim

straight up until it is tight against ceiling.

6. Lamping (Fig. H and I)

Make sure that power is OFF when lamping or relamping.
Remove 

Swivel Trim

from 

Housing

by pulling straight down

(Fig. H). Place 

Glass Lamp Guard

between 

Lamp Spring

.

Place Lamp between 

Lamp Spring

until face of Lamp sits firmly

onto 

Glass Lamp Guard

(Fig. I). Attach Socket to Lamp. Insert

Swivel Trim

with Lamp and 

Glass Lamp Guard

back into

Housing

. (If TAL type lamp is used, do not use glass lamp

guard.)

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local 
or Federal code specifications. To assure full compliance with local codes and regulations, check with your
local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before
proceeding.

Retain these instructions for maintenance reference.

®

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA  02720

CAUTION:
• Lamp manufacturers require the Glass Lamp Guard

be in place before energizing lamp (with the
exception of TAL lamps), and that great care must
be taken to insure lamp is fully cooled before
relamping.

• Use only reflector trims provided by Lightolier Inc.

Use of other manufacturers’ reflector trims voids
the Underwriters Laboratories listing and could
constitute a fire hazard.

NOTES:
• Low voltage fixtures should be dimmed only with

special dimmers intended specifically for that pur-
pose. Use Lightolier Lytemode

®

, Scenist

®

,

Crescendo VA

®

, Neptune VA

®

, Precision VA

®

,

Easyset VA

®

, Sunrise VA

®

, Radiant VA

®

, or equiva-

lent products by others; or variable autotransform-
ers or electronic dimmers intended for use with
low voltage fixtures.

FIG. F

FIG. I

FIG. H

FIG. G

FIG. E

Reviews: