19B
-
2
EXHAUST
General information
K7J or K7M, and 710
19B
3 - Operate tool Mot. 1199-01
Position the tool on the pipe.
Tighten the bolts on the cutting tool so that it grips the
pipe.
Turn the cutting tool with the handle while gripping the
pipe.
As the cut is made, continue to tighten the bolts on the
tool (do not overtighten the tool on the pipe, to avoid
distortion during the cutting operation).
4 - Fitting the after-sales sleeve
To prevent any exhaust leak, position the sleeve cor-
rectly on the two lugs (3) and apply some exhaust
MASTIC (see 04B, Consumable products, Conditio-
ning) to the inside of the sleeve:
- slide on the sleeve fully, positioning it on the lugs (3)
on the old part of the pipe,
- adjust the sleeve diameter by tightening gently,
- mount the new component fully onto the lugs (3).
Torque tighten the sleeve tightening nut (2.5 daNm).
102118
95478
3
100649
WARNING
Make sure:
- that the « sleeve tightening nut - bolt » assembly is
vertical, with the nut facing downwards, to prevent
any risk of underbody contact,
- to adjust the new component so that the cut zone
marks are aligned (X1),
- that the two marks are flush with both sides of the
sleeve.
- Do not reuse an old sleeve.
X1