23
Timber Ax
Maintenance
Grease Points Location (Cont'd)
Use a #2 general purpose lithium based grease unless
noted otherwise.
NOTE:
Replace any broken or missing grease fittings.
Be sure to clean fittings before greasing.
8
NOTE:
Lubricate the grease point every “X” hours
indicated on the decal adjacent to the grease
point.
Numbers below after “Location” correspond to grease
point locations on opposite page.
See “Timber Ax Identification” on page 10 for
component location and identification.
• Belt Tensioner Grease Fitting
Location: (1) -
Left side of the Timber Ax, at the base
of the rear push bar arm support, adjacent
to the motor shield. Top fitting.
NOTE:
Remove the belt cover when lubricating
the fitting. Visually inspect the idler pulley
components while lubricating. Do Not over
lubricate the idler tensioner shaft.
NOTE:
Over-lubricating may be transferred to the belt,
causing the belt to slip, resulting in loss of rotor
RPM speed and loss of power to the rotor.
Interval:
Every 50 hours of operation.
• Rotor Bearings Grease Fittings
Location: (2) Left side:
Left side of the Timber Ax, at
the base of the rear push bar arm support,
adjacent to the motor shield. Bottom fitting.
(3) Right side:
Located on the right side
of the Timber Ax, at the top of the bearing
guard.
NOTE:
Rotor bearings cannot be damaged by over-
greasing. Grease fittings until a small amount of
grease is purged from the bearing.
Interval:
Daily or every 8 hours of operation.
• Pusher Bar Grease Fittings
Location: (4, 5) -
Located on the lower end of the
pusher arms on the front side of the Timber
Ax, both left and right side. Grease fitting
is located on the back side of each pusher
arm (see detailed photo on opposite page).
Interval:
Every 50 hours of operation.
Overhung Load Adapter
NOTE:
If replacing bearings or seals in the overhung
load adapter, be certain to refill with 6 oz. of
hydraulic fluid after reassembly.
Summary of Contents for Timber Ax 63TA
