LOFTNESS Timber Ax 63TA, Owner'S Manual

Page: 23 / 62

17 Timber Ax
Pusher Bar Adjustment
NOTE: Adjusting the pusher bar requires two people or
the use of an approved lifting device to support
the push bar as it is being adjusted.
Remove bolt (1), washer (2), and bushing (3) from the
lower storage position. Loosen the two bolts (4 & 5) to
allow the pusher bar to pivot forward. Repeat procedure
on opposite side.
Move the pusher bar forward.
Align the rear arm (6) with the desired hole from the front
as shown.
Install bushing (3), washer (2), and bolt (1) and tighten
securely against the frame. Tighten bolts (4 & 5). Repeat
procedure on opposite side.
Set-up Instructions
Approved
Lifting Device
Approved
Lifting Device
5
4
6
2 1 3
5
4
Skid Adjustment
NOTE: The skid(s) can be adjusted to increase or
decrease the distance between the ground and
the rotor.
Remove the five nuts (1) and raise or lower the skid to
the desired height. Re-install the five nuts and tighten
securely against the skid.
1 1
1
2
3