15
Timber Ax
Set-up Instructions
WARNING:
Locking-wedge pins must extend
through the holes in attachment-mounting
plate. Levers must be fully down in the locked
over-center position. Failure to secure wedge
pins can allow attachment to come off,
causing serious injury or death.
Hydraulic Connections
NOTE:
The hydraulic hose quick couplers shown above
are not supplied with the Timber Ax.
Install the Timber Ax quick couplers to the loaders
hydraulic system.
NOTE:
The case drain quick coupler of the Timber Ax
must be connected to the loader’s auxiliary
hydraulic system for proper operation of the
attachment. Failure to do so may result in severe
damage to the hydraulic motor.
Installing the Timber Ax to the Skid
Loader
Fully raise the attachment-locking levers on the loader
mounting plate.
Tilt the loader mounting plate ahead. Drive forward with
the loader and hook the top edge of the loader mounting
plate under the top flange (1) on the Timber Ax mounting
plate. Be careful not to damage the locking levers on the
loader mounting plate.
Tilt the loader mounting plate back until the Timber Ax
mounting plate is firmly against the loader mounting
plate, but DO NOT lift the attachment off the ground.
WARNING:
Before you leave the operator’s
seat: Lower the lift arms, put the attachment
on the ground. Stop engine and remove
ignition key. Engage the parking brake.
Locking-wedge pins (2) must extend through the holes in
attachment-mounting plate.
1
2
Case Drain
Pressure
Tank
Summary of Contents for Timber Ax 63TA
