17
The manufacturer refuses all responsibility for possible damages to things or people, resulting
from a wrong installation or from an improper, incorrect or unreasonable use of this equipment.
1. INSTRUCTIONS FOR THE INSTALLER
IMPORTANT NOTICE:
The operations indicated below must be followed by qualified personnel
exclusively, in conformity with the regulations in force.
The manufacturing firm refuses all responsibility for damages to people, animals or
things, resulting from the failure to comply with such provisions.
1.1 INSTALLATION
Installing the top
The appliance is designed to be embedded into heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 65°C besides the room one.
The equipment must not be installed near inflammable materials, such as curtains, cloths, etc.
Make a hole in the top of the piece of furniture, with the dimensions indicated in fig.3, at a
distance of at least 50 mm from the appliance border to the adjacent walls.
Any possible wall unit over the cook-top must be placed at a distance of at least 760 mm from
the top.
It is advisable to isolate the appliance from the piece of furniture below with a separator, leaving
a depression space of at least 10 mm (fig. 4/fig.10).
In case of installation on hollow compartment with doors you need to place a separation panel
under the hob. Keep a minimum distance of 10 mm between the bottom of the device and the
surface of the panel, which must be easily removable to allow sufficient access for any technical
assistance.
If the hob is going to be installed on the top of an oven, precautions must be taken to guarantee
an installation in accordance with current accident prevention standards. Pay particular
attention to the position of the electric cable and gas pipe: they must not touch any hot parts of
the oven.
Moreover, if the hob is going to be installed on the top
of a built in oven without forced cooling ventilation, proper air vents must be installed to
guarantee an adequate ventilation, with the lower air entering with a cross section of at least
200 cm2, and the higher air exiting with a cross section of at least 60 cm2.
Fastening the top
Every cook-top is equipped with a special washer. For the installation proceed as follows:
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the washer S along the external border (fig. 5).
- Introduce and place the cook-top in the hole made in the piece of furniture, then block it with
the V screws of the fastening hooks G (fig. 6).
Installation room
This appliance is not provided with a device for exhausting the products of combustion.
Therefore, it is necessary to discharge these smokes outside. The room where this appliance is
installed must have a natural air inflow, so as to ensure a regular gas combustion and room
ventilation: the necessary air volume must not be lower than 20 m3.
