Operation
WeftMaster CUT-iT
www.loepfe.com
19
Modes
There are 4 different current flow modes:
n
«Standby»
(ready for operation)
– The
«Standby mode»
describes the time in which the weaving machines is idle. Predefined current
flows through the cutter wires during this time.
This achieves an optimum output temperature for the machine to run.
n
«WStandby»
(Minimum standby time)
– The WeftMaster CUT-iT maintains a minimum standby time ro allow the cutter wires to cool down
when the weaving machine stops.
– If this minimum standby time is not maintained and the
«Run command»
comes too soon after a
previous run, the current remains in the
«WStandby-Modus»
for the predefined time and the
standby time is delayed. This minimum time is defined in system parameter 87 (as standard value
with 0).
n
«Boost»
(start-up current)
– The
«Boost mode»
describes the weaving machine startup time. The predefined current flows
through the cutter wires for a limited time.
– This current heats the cutter wires as quickly as possible to operating temperature.
n
«Run»
(running current)
– The
«Run mode»
describes the time in which the weaving machines is running. The predefined
current flows through the cutter wires during this time.
4.3.5
Test mode
ü
The weaving machine is idle.
ü
WeftMaster CUT-iT is in Standby mode.
1.
Press within a maximum time of 1 minute (maximum test time adjustable in system parameter
85).
ð
WeftMaster CUT-iT switched to Run mode during the time the button is pressed.
