Service manual OEM treadmill V2.03
51
5.1 Messages
During operation of the treadmill a full diagnostic analysis is running continuously, in case an error
occurs the user needs to be warned and an audio signals will sound. LED’s on the Treadmill Control
Module will blink to indicated what might be the cause of the problem. The order in which they blink
can be compared with table 1 in this chapter.
This chapter describes the explanation of the error codes.
When the emergency circuit is activated you will hear 5 short beeps followed by a pause of 10
seconds. This error will repeat till the cause has been taken.
For safety reasons the diagnostic of the treadmill can give an error during the self-test or during use.
This error will sound 5 long beeps followed by a pause of 10 seconds. This error will make the
treadmill stop. You could switch off the treadmill wait till the van has stopped turning and restart the
treadmill.
If the problem still occurs you could remove the cover of the treadmill and watch for the code that has
been showed by the blinking LED’s D10,D11 and D12. ( figure 2)
During the 5 long beeps the three LED’s D10,D11 and D12 will light up for one second. This must
been seen as CODE I. After that, still within the 5 long beeps there will be a pause from 1 second and
then the LED’s D10, D11 and D12 will light up again. This must be seen as CODE II. (figure 1)
Write down the code and compare them with the table in this document.
In case the angle measurement is malfunctioning the treadmill will warn with a beeb: long-silence-
short-silence-short, after this only the speed control is available.
Figure 1
Summary of Contents for OEM
