Lode OEM, Service Manual

Page: 52 / 68

Service manual OEM treadmill V2.03 52
CODE 1 CODE 2
CODE DESCRIPTION D12 D11 D10 D12 D11 D10
TCM_ERRORS
NO_TIMER_AVAILABLE No software timers available
Exchange TCM 0 0 1 0 0 1
ELEV_TIMEOUT Time out on elevation, no change seen
in elevation for the last 2 seconds, when
expected.
Check wiring to grade motor or replace
grade motor. 0 0 1 0 1 0
WATCHDOG_EXPIRED
Watchdog timer expired by critical error
in embedded software.
Restart treadmill or replace TCM
0 0 1 0 1 1
GENERAL_STATUS_ERROR General errors that may occur under
normal conditions:
•
WATCHDOG ERROR
•
EXTERNE WATCHDOG
ERROR
•
RAM ERROR
•
MODULE ERROR
0 0 1 1 0 0
RAM_ERROR During selftest the RAM will be tested.
If a problem occurs this code will be
shown. 0 0 1 1 0 1
COM_GUARD_TIMER_FAILURE Error on data exchange on internal bus.
Check wiring 0 0 1 1 1 0
FREQUENTIE REGELAAR
AC_DRIVE_ERROR Motor controller error
Check motor controller or replace motor
controller 0 1 0 0 0 1
AC_DRIVE_COM_ERROR Communication loss between motor
controller and TCM. Check motor
controller, service required 0 1 0 0 1 0
AC_DRIVE_CONFIG_ERROR During selftest the motor controller has
to be initialized, if fails this code will be
shown. Check motor controller power.
Service required 0 1 0 0 1 1
COMMUNICATIE
NO_MODULE During selftest the treadmill checks for
communication modules, if fails this
error will be shown. Check wiring
replace communication module 0 1 1 0 0 1
COM_GUARD_ERROR Time out on internal bus, restart
treadmill service required when
problem occurs. 0 1 1 0 1 0
GUARDING ERRORS
SPEED_GUARD_ERROR
Difference between target speed in
firmware and target speed in motor
controller exceeds limits
1 0 0 0 0 1
SPEED_GUARD_ERROR2 Difference between target speed in
firmware and target speed in motor
controller within limits out of range too
long. Check belt tension and motor
controller 1 0 0 0 1 0
TEST-ERRORS
MAN_ERROR_TRIGGER
For factory purpose only
1 1 1 0 0 1
Tabel 1