LOBSTER R2B1, Instruction Manual

Page: 31 / 35

ENGLISH
31
Phenomenon Cause Corrective action
The mandrel
collapses in the
frame head. Forgetting to release
mandrels.
Discharge the mandrel to
the mandrel collector before
performing the following
operations.
A rivet cannot
be cut in a single
operation. The rivet is not suitable for
the thickness of the plate
in use. Use a rivet suitable for the plate
thickness.
Assembly of the jaw case
part is inappropriate. Check the installation order of the
parts inside the jaw case.
The Jaw is worn. Replace the jaw.
Insufficient jaw lubrication. Clean the inside of the jaw and
jaw case head, and apply shrimp
lubricant to the back of the jaw.
(Refer to page 22-25.)
The motor does
not start up. The battery pack is not
charged. Charge the battery pack.
Dirt is attached at the
contact point between the
battery pack and machine
body. Remove the dirt.
The protection circuit of the
battery pack has started up
due to an overload. Remove the cause of the overload.
The mandrel collector is
disconnected. Mount the mandrel collector.
The work light does
not light. The work light is set to
disabled. Change the setting by using the
work light setting button.
(Refer to page 21.)
The operation time
of the battery pack
is very short even
after it has been
charged correctly. The battery pack has
reached the end of its
service life. Purchase a new battery pack.
When a fully
charged battery
pack is charged
again, the charging
lamp lights. This occurs because it
takes a while to detect the
fully charged condition. In a short while, the charging
complete indication appears.
Noise interference
on a TV or radio
during charging. This occurs because
charging is controlled by
using high frequency waves.
Charge this machine by using
another receptacle. Keep this
machine away from the radio or
TV set.