Adding oil
◎
Oil addition should always be carried out by following the simple procedure given below.
1
2
Turn off the air supply.
Use the accessory hex key wrench to remove
the bleed plug, and attach the priming pump
(syringe unit) to the hole.
A
Make sure that the priming pump contains the
necessary amount of oil beforehand.
A
If you hold the main body of the priming pump
while tightening, the pump may become damaged.
Use pliers to hold the nozzle of priming pump while
tightening.
t
CAUTION 1 (P.3)
D
ISA
S
SE
M
B
LY
4
3
Gently depress the piston of the priming pump.
A
When enough hydraulic oil has been added, the
piston will become hard to push. Stop adding oil at
this point.
A
D
D
IN
G
O
IL
R
E-
A
SSE
M
B
LY
4
Install the bleed plug.
STORAGE
¡
Store in a place which is well-ventilated and free from excessive dust and humidity, and where there
is no danger that the tool will fall.
¡
If not using the tool for an extended period of time, carry out a maintenance inspection before storing
it away.
¡
To increase the working life of the tool, it is recommended that you give it periodic overhauls. Contact
the place of purchase or your nearest “LOBSTER” dealer for any overhauls and repair work required.
(A charge will be made for this service.)
Piston
Nozzle
Bleed plug
Priming pump •
(syringe unit)
14
英語／E
N
G
L
ISH
AR-2000S-M-H(A)取扱(GB):AR-2000S̲M-H(A)取扱(GB) 14/08/27 13:55 ページ 14
