Replace the nosepiece to conform to the size of
the rivet being used.
The rivet size indicates the diameter of the rivet.
NOTE:
¡
Different-sized rivets can be used just by replacing the
nosepiece.
¡
At the time of purchase, the AR2000S
(A)
and AR2000M
(A)
are fitted with a 3.2 nosepiece, and the
AR2000H
(A)
is fitted with a 4.8 nosepiece.
¡
If you wish to use other sizes, use a spanner to remove and replace the nosepiece.
7
英語／E
N
G
L
ISH
PREPARATION BEFORE USE
1
2
3
4
5
Use the air regulator to adjust the operating air pressure to 0.49 ~ 0.59 MPa
(5 ~ 6 kgf/cm
2
, 71 ~ 85 psi).
A
If installing stainless steel rivets with a diameter of 4.8 mm (3/16") with the AR2000M
(A)
,
set the air pressure to 0.54 ~ 0.59 MPa (5.5 ~ 6 kgf/cm
2
, 78 ~ 85 psi).
t
WARNING 1 (P.1)
Remove the dust-proof cap on the bottom of
the tool, and then connect the rotary joint unit.
A
Connect the end of the rotary joint unit which has the
O-ring fitted to the tool.
Install the safety cap to the tool.
Set up the compressor, and be sure to install an
air filter, air regulator and air lubricator (3-device
set) between the compressor and the tool.
t
WARNING 2 (P.1)
t
WARNING 4 (P.1)
ATTENTION:
If the air pressure is too high, damage to parts may occur. If the pressure is too low,
some size of the rivet may not be correctly installed (cut).
ATTENTION:
In case of the usage in the cold district, the
moisture contented air in the tool body may be
frozen on the inside cylinder surface. As the result,
it may not work. To dehydrate, we recommend to
add the air-dryer unit to the normal three units
(Regulator, Filter, and Lubricator).
Rotary joint
O-ring
Safety cap
Air filter
Air regulator
Air lubricator
Body (flange)
Mandrel (shaft)
Rivet diameter
t
CAUTION
Nosepiece Selection
Conform the size to be used, and replace the nosepiece with the corresponding one.
Wrong size selection of the nose piece will cause jamming the spent mandrel inside.
AR-2000S-M-H(A)取扱(GB):AR-2000S̲M-H(A)取扱(GB) 14/08/27 13:55 ページ 7
