LNS SERVO S3 T, Instruction Manual

Page: 79 / 120

CHAPTER 7: OPERATION 77
QUICK LOAD SERVO S3T
3. SET-UP
Please read the safety instructions provided at the beginning of this manual before
handling the following devices.
All handling, adaptations and settings required by the bar feeder to carry out a specific job are part of the
set-up.
A few simple operations are necessary to prepare the device to handle another range of diameters.
The set-up must be modified when following parameters change:
1. Bar stock diameter
2. Bar stock shape
3. Part length
3.1. Bar feeder mechanical setup
3.1.1. Adaptation of the pusher
Please read the safety instructions provided at the beginning of this manual before
handling the following devices.
Depending on the bars to be loaded, it may be necessary to change the pusher. See CHAPTER 6 of this
manual: Pusher changeover section.