LNS SERVO S3 T, Instruction Manual

Page: 65 / 120

CHAPTER 6: GENERAL DESCRIPTION 63
QUICK LOAD SERVO S3T
5.3. Replacement of the pusher
1.
Bring the loading table to the working position
(lowered), then place the bar feeder in the STOP
position (using the remote control).
2.
Undo the retaining screws (A) enough for them
to release the recess (C) which holds the pusher
(B) in the connection piece (D) .
3.
Move the pusher forward, sliding it inside the
guiding bushing (E) .
4.
When the rear of the pusher been freed enough
for it to be removed, pull the guiding bushing (E)
backwards to remove it from its housing.
5.
The pusher is now released and can be removed.
6.
Insert the new pusher into the opening and insert
the guiding bushing.
7.
Insert the rear of the pusher into the connection
piece and push it in fully.
8.
Tighten the retaining screws so that they sit in
the recess in the pusher.
9.
Check that the mechanical stop is correctly
positioned (see next point).