LNS SERVO S3 T, Instruction Manual

Page: 92 / 120

90 CHAPTER 7: OPERATION
QUICK LOAD SERVO S3T
Auxiliary end of bar position (may be not visible)
Depending on the lathe and its options, the auxiliary end of bar may be used in several ways. For
example, for the opening of an additional front rest installed at the rear of the lathe spindle. The
procedure is the same as this for the end of bar signal.
4.2.4. Torques
Torque set according to the diameter for
part feed out (%)
Depending on the bar diameter, the feeder
suggests a suitable thrust torque. The
operator can modify this torque if required.
When the material to be loaded has a high
specific weight, the torque must also be high.
Conversely, low specific bar weight requires
low torque.
Torque set according to the diameter of
the material in quick feed (%)
Same principle as for the part feed out
torque, this time applied to quick feed.
4.2.5. Miscellaneous functions
Language
This parameter allows to adapt the language
in which the messages will appear,
depending on the country of destination of
the bar feed system
(for practical reason, it
is not necessary to stop the bar feeder to
select a language)
.