LNS ECO LOAD, Instruction Manual

Page: 10 / 67

6
ECO LOAD
2.4 Horizontal alignment
Setting the level:
Fit the plate (A) that is supplied with the
accessories to the feeder. Place a spirit-
level (B) thereon and adjust with the bolts
(C). Ensure that the weight is evenly
distributed over all the bolts.
For retraction device, refer to the spare
parts diagrams 11 (at the end of this
manual).
Alignment :
Once the level is correct, move the pusher-bar forward until it is behind the lathe spindle.
Move the feeder laterally until the Pusher-bar can enter the spindle without touching it.
You can now check by sighting down the inside of the lathe towards the point where the
spindle enters.
Correct the alignment of the ECO LOAD until you are satisfied with it.
2.5 Securing to the floor
Once the feeder has been aligned, secure the leveling bolts on their plates (even pressure)
and drill into the floor. Bolt the machine to the floor using the appropriate anchors.
For retraction device, refer to the spare parts diagrams 11 (at the end of this manual).