LNS ECO LOAD, Instruction Manual

Page: 47 / 67

43
ECO LOAD
Alarms Alarm text Description
e11
Emergency stop 1) Bar feeder emergency stop button was pressed.
2) The lathe emergency stop button was pressed
( the emergency stop loop must be connected to the
lathe )
3) Air pressure is missing. The actural problem could
be air pressure missing, AS1 or AS2 sensor is
mulfunction or soft start fitting is broken.
4) The safety switch sensor is OFF/OPEN ( sensors
attached in the main access cover or bar feeder
retraction rail )
e12
-
F1 is smaller than F3.
e13 -
The pusher does not return to home position after
1) FIRST FEED
2) remnant ejection
e14 -
Part too short. This alarm will be activated when
1) the feeding length is 10mm smaller than the part
length setup
2) the part length is longer than 15mm
3) F1 be set “1”