LNS ECO LOAD, Instruction Manual

Page: 36 / 67

32
ECO LOAD
6.3 Adjusting the slant of the loading table
ATTENTION : Before starting to adjust the loading table, you must ensure that the
compressed air is connected and the pressure is at least 6 bar.
The slant of the bar magazine will depend on the cross-section of the bar stock to be loaded :
Round bar stock : 3 - 5 degrees
Hex bar stock : 20 degrees
Procedure :
C
Press the button to switch to manual mode
C
Press the button to set the rake to 0
o
C
Loosen screws I and II
C
Adjust the rake by raising or lowering nut III
C
Retighten screws I and II