LNS ECO LOAD, Instruction Manual

Page: 50 / 67

46
ECO LOAD
8.3 Description of wiring
General comment
The interface diagram located in the door to the electrical housing will help you to simply
interface.
The relays, D1-D7, on the control card are not live.
Inputs D01-D03 require a 24VDC power supply.
Use the 24v from the feeder and free power terminals in the lathe.
8.4
Description for working mode
8.4.1
Working mode
Connection by the chuck signal only (D01).
If switches 1 & 2 are OFF, the working program requires an "open chuck" signal (D01) to
feed in the workpieces.
When the "Bar-end point" is activated, the feeder awaits signals (D01) and (D02) to start the
feed cycle.
The end of the loading cycle is confirmed by relay D2 as soon as the bar has reached position
"F6".
Connection with the chuck signals (D01) and M-code (D02)
If switch 1 = ON and switch 2 = OFF, the work program now requires a chuck signal (D01)
and an M-code signal (D02) to feed the workpieces.
The "M-code" will be confirmed once the bar-pushing screw-jack is supplied with
compressed air.