LMI 241 Series, Configuration And Mastering Instruction, Page: 8 / 13

E-mail support
techsupport@lmicorporation.com
LMI Corporation
Phone support
(810) 714-5811
15. If changes to this screen are needed, press
▲
or
▼
to highlight either “Type”, “Master Type”,
“Master With”, or “Zero Before Read” then press <enter> to toggle the different choices.
16.
To make changes to the “Scale” or “Zero Master” press
▲
or
▼
to highlight “Scale” or “Zero
Master” and press <enter>. This will bring up the numeric keypad. Key in the new value and
press
►► to accept.
17.
Key in the desired value buy using the
▲
, ▼ , ► , or ◄ to highlight the first number, press
<enter>. Repeat until the number is completed and press ►► to accept the new value.
18.
Once the “Configure Gages” screen is set press ► and a pop up will appear if any changes
were made. Highlight “Save to current gage” and press <enter> if the changes were
Form: CA 030
December 28,
2004
R:\Quality\Calibration Instructions\CA 030.doc
Page 8 of
13