12
Figure 7 Fastening the Z-axis Adjustment Knob (with Z-axis locking screw)
15.
Open the sensor mounting finger by unscrewing thumbscrew until the sensor head locking pin is no longer visible.
16.
Connect the controller, delivered with the package, to its connector on the left side of the scanner frame.
Push the connector in place (approximately 5 mm / 0.2") and tighten the nut by turning it clockwise with Phoenix
Contact tool TSD 04 SAC (1208429) and SAC BIT M12-D15 (1208432).
You can place the controller onto a magnetic holder. There is one magnetic holder on each side of the device.
Z-axis locking screw
Brake mechanism adjustment screw
(Allen screw)
Z-axis adjustment knob
