Safety instructions
8
2.3. Electromagnetic compatibility
This product is compliant with the national standards regarding conducted and radiated emissions.
Please see chapter 10. Technical data.
Important Note
To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is
permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure
requirements and void user’s authority to operate the device.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in an installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure compliance was demonstrated at a distance of 20 cm or greater between the human body and
the device antenna. For your safety, this minimum distance should be maintained while using the equipment.
2.4. Safety considerations for the LM DTS
TM
Reader
Installation and usage must comply with all safety instructions and warnings in this manual. Installation and
usage must also follow all applicable local or national statutory requirements and safety standards.
Service of the product is only to be performed by authorized service personnel.
In this manual are shown all the allowed maintenance actions for the user. Any other procedures are strictly
prohibited. Before carrying out any maintenance work, read and understand the maintenance instructions.
2.5. User pre-requirements
This manual assumes that the local administrator is familiar with the operation of the LM DTS™ Reader and has
a good working knowledge of the LM DTS™. It is assumed that the administrator has received the necessary
training from LM
TM
.
The local LM DTS™ administrator should provide necessary training for all other personnel who will be working
with the LM DTS™ system.
2.6. Intended and prohibited uses of the product
LM DTS
TM
Reader is used to record and track (chosen) activities made to articles registered in the LM DTS™.
Articles can be dental hand instruments or dental materials.
Do not use LM DTS
TM
Reader where it is not intended to be used. If you are unsure about your operation, please
contact your local dealer or place of purchase. The LM DTS
TM
Reader is not intended for use in any of the following
situations:
• In hazardous (explosive) atmosphere
• In situations where the LM DTS
TM
Reader may come in contact with water
• In situations where the LM DTS
TM
Reader will be subject to extremes of heat or humidity. See the
