LIVARNO LUX 14117401L, Operation And Safety Notes

Page: 19 / 21

19 GB
Start-up / Changing the bulb / Maintenance and Cleaning / Disposal Introduction / Safety
Start-up
Mounting the light
Note: Two people required for assembly.
Note: When assembling the support tube, be sure
not to damage the mains lead
10
inside the lamp.
Loosen the lock nut
5
.
Pull the upper support tube
4
out of the middle
support tube
6
.
Tighten the lock nut
5
to secure the joint.
Secure the joint using the socket screw (small)
12
and the socket head wrench (small)
13
.
Now screw the upper support tube clockwise
into the lower support tube
7
.
Carefully pull the mains lead
10
out of the
support tube.
Screw a snap ring
9 a
onto each socket screw
(large)
9
.
Push the socket screws (large)
9
through the
base
8
from below.
Place the decorative disc
9 b
over the socket
screws from above.
Secure the support tube to the base
8
using the
socket head wrench (large)
14
.
Remove the lamp ring
3
from the lamp
socket
1
.
Place the fabric lamp shade
2
over the socket
and secure the fabric lamp shade
2
using the
lamp ring
3
.
Use a lint-free cloth when installing the lamp
15
.
Insert the E27 bulb
15
into the socket and turn
clockwise to secure.
Adjust the lampshade
2
to the desired position.
Plug the connector into a socket that has been
professionally installed.
Note: The heavy net weight of the fabric lamp
shade
2
greatly limits lateral positioning of the
fabric lamp shade
2
.
Your light is now ready to use.
Switching the light on / off
Switch the lamp on or off using the ON / OFF
switch
11
.
Changing the bulb
CAUTION! RISK OF ELECTRIC SHOCK!
When replacing the illuminant, first disconnect the
light from the mains. To do so, remove the fuse or
switch off the circuit breaker in the fuse box
(0 position).
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the light to cool down
completely.
Only replace the lamp once it has completely
cooled down.
Use a clean, lint-free cloth when replacing the
bulb
15
.
Turn the defective bulb
15
anticlockwise out of
the bulb socket.
Only use LED illuminants
15
with a maximum
output of 7 W and E27 base.
Insert the new bulb
15
into the bulb socket and
turn it clockwise to tighten it. Ensure that it is
positioned correctly.
Reinsert the fuse or switch the circuit breaker
back on.
Maintenance and Cleaning
DANGER OF ELECTRIC
SHOCK! First unplug the mains plug from the socket.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the lamp to cool down
completely.
DANGER OF ELECTRIC
SHOCK! For electrical safety, never clean the light
with water or other liquids, or immerse it in water.
Do not use solvents, benzene or similar sub-
stances. They could damage the light.
Only use a dry, lint-free cloth for cleaning.
Disposal
The package and packaging materials consist entirely
of environmentally friendly materials. They can be
disposed of at your local recycling facility.