Page 5
SAFETY WARNING
Installation should only be carried out by suitably qualified personnel in accordance
with local wiring regulations.
The display must be earthed.
Only suitably qualified personnel to open and work inside the display modules
including changing backlight.
Disconnect from mains supply by removing the mains cable before opening the back
panels. The appliance connector is used as the disconnect device.
The display front surface should be cleaned with a lint free cloth lightly dampened
with Iso Propyl Alcohol. Do not use other solvents to clean.
Steel toe cap safety footwear should be worn when lifting or handling the units.
Appropriate lifting equipment should be used. Modules should not be lifted by one
person.
The equipment must be installed securely and bolted to the ground to avoid toppling.
Each module must be bolted to each of its neighbouring modules and if necessary
securely attached to a fixing point above the display to avoid toppling.
A structural engineer should be consulted prior to installation if there is any doubt
about the structural integrity of the surface on which the display is to be built.
The modules should be stacked no higher than 4-high without additional structural
support. Seek advice from a suitable qualified structural engineer.
This equipment complies with IEC60950-1:2002 Information Technology
Equipment. Safety. General Requirements.
