Page 16
6.0 Settings for Scaler and MDU controller
The MDU unit has 6 nine-pin D-SUB type outputs on the rear of the unit.
The output from these connectors is fixed depending on the format of display being
driven. Below are details of which output drives which module in the various formats.
A number can be allocated to the outputs on the rear of the MDU unit as follows:
When viewing the display from the REAR, connect the MDU outputs to the modules as
follows (the convention is that output ‘1’ from the MDU is ALWAYS the bottom-right
module (when viewed from the rear of the screen) and then 2,3,4,5,6 follow, first along the
ROWS, and then for the next COLUMN above.
*Rear view of connections
from Modules to MDU.
Mode Setting
MDU
Graphics Mode
TVone
Resolution
0
2
3
4
5
107
111
108
109
110
5
4
3
2
1
Mode2
6
3
5
2
4
1
Mode3
4
2
3
1
Mode0
6
4
2
5
3
1
Mode4
6
5
4
3
2
1
Mode5
On the front of the MDU is a push button, which can scroll graphics mode through modes
0-7 and an on/off switch In order to set up the MDU and the TVOne C2-2200 for each of
the above module configurations, the following settings must be selected:
