Page 18
On the front of the TVOne C2-2200 box, there is an LCD screen and a ‘joystick’ to allow
various parameters to be adjusted. Follow the on screen menus to adjust the output
resolution setting.
12V DC power supplies are supplied with the units. These are required to power both the
MDU and the TVOne C2-2200.
If using a VGA input to the TVOne and more than one set of controllers is being used,
each TVOne box should be driven with the same VGA source via a multi-way VGA
distribution amplifier.
Setting the TVOne C2-2200:
Normally, the settings on the C2-2200 will result in the whole VGA image being displayed
on a 3x2 (mode 3) module display. In order to adjust this so that (for example) only the
left half or right half of the image is displayed (i.e. for use as half of a 4x3 module
display), the settings will need to be adjusted by using the buttons and multi-directional
switch on the front of the unit.
At any time during this procedure, pressing and holding in the push button in the centre
of the multi-directional switch will SAVE the settings to memory so that they remain
even after a power down cycle.
In order to adjust the settings to show the right or left half of the VGA source image, use
the push buttons and multi directional buttons to change the H/V zoom % in the zoom
menu to stretch the picture to twice it’s original width and then adjust the H/V zoom
pan% to pan across to the left or right half as required.
