Lissmac SBM-L 1000 G1S2 ALU MIX, Operating Manual, Page: 6 / 82

Table of Contents
Grinding Machine SBM-L 1000+1500 G1S2 ALU MIX 6
7.1.2 Removing grinding belt drive poly-V belt ............................ 62
7.1.3 Putting on the poly-V belt .................................................... 63
7.1.4 Tensioning the poly-V belts ................................................. 64
7.1.5 Replacing sliding block drive toothed belt .......................... 65
7.2 Replacing S-unit drive belts ............................................................ 66
7.2.1 Remove support bar ........................................................... 66
7.2.2 Removing the V-belts .......................................................... 66
7.2.3 Installing the V-belt ............................................................. 67
7.2.4 Tensioning the V-belts ......................................................... 68
7.2.5 Installing the support bar .................................................... 68
7.2.6 Replacing the V-belt on the back of the S-unit ................... 69
7.2.7 Tensioning the V-belt on the back of the S-unit .................. 70
7.3 Lubrication points/ Hydraulic oil ...................................................... 71
7.3.1 Left guide shafts lubrication points ..................................... 71
7.3.2 Right guide shaft lubrication points ..................................... 71
7.3.3 Lubrication points of G unit upper operator side ................. 72
7.3.4 Lubricating the S-unit belt Flanged bearing ........................ 72
7.3.5 Check hydraulic oil level ..................................................... 73
7.4 Cleaning .......................................................................................... 74
7.5 Cleaning interval ............................................................................. 75
8 Service .................................................................................................... 76
8.1 Service intervals .............................................................................. 76
8.2 Maintenance material ...................................................................... 76
8.3 Tightening torques .......................................................................... 77
8.4 Troubleshooting .............................................................................. 78
8.5 Customer service ............................................................................ 79
9 Taking out of operation and disposal ................................................. 80
10 Warranty ................................................................................................. 81