Dive Computer
User Manual
Liquivision Products, Inc
-
65
-
Revision 3.2 Software 2.58
X E O O-r ings
You should inspect your battery cap O-ring with every battery change. Check for cracking, damage or
dirt. If you choose to replace your O-ring, always make sure to clean the battery cap properly to remove
any residue that may prevent a good seal and to lubricate the new O-ring with silicone O-ring lubricant.
Only O-rings contained in Liquivision battery packs can be guaranteed to perform to Liquivision
standards.
To order spare batteries and O-rings for your XEO, please contact your local Liquivision dealer.
WARNING
Attention, LYNX T1 Transmitter owners:
Please note that the O-rings that were provided with the XEN, XEO, and KAON before June 1
st
2013
are NOT compatible with LYNX T1Transmitters.
For more information about O-ring compatibility, please consult:
http://www.liquivision.com/docs/Lynx_User_Manual.pdf
How To Determine XEO Battery Life Remaining
The ER14335M XEN batteries can provide up to 46 hours of dive time with your unit while
ER17335M batteries can provide up to 90 hours of dive time with your unit (low brightness, green font,
battery used within a month of initial use), although 20-30 hours for the ER14335M batteries and 40-60
hours with the ER17335M batteries is more typical if you use the standard Liquivision color scheme on
medium brightness and all the dives are done within a month of first using the battery.
The rechargeable LFP123A batteries usually provide 14-18 hours of dive time and can be recharged up
to 1,000 times.
Battery life is shown by the battery indicator on your XEO.
•
A
Green
battery icon means that you have enough battery power to complete a normal 2 hour
dive. The safest way to perform a long dive (5+ hours) is to insert a fresh battery prior to the
start of your dive.
•
If the battery icon is
Yellow
on the surface
, you should change your battery before beginning
your next dive.
•
If the battery icon is
Yellow
underwater
, you likely have enough battery life to complete your
dive.
•
If the battery icon is
Red
on the surface
, you MUST change your battery immediately.
•
If the battery icon is
Red
underwater
, you should stop your dive and begin your ascent
immediately, while still following proper ascent protocols (respect the ascent speed and Safety
Stop).
You should always check the battery life remaining on the surface, prior to beginning your dive, by
briefly entering simulator mode with your unit. Your XEO uses more power in dive mode than in
surface mode. It may show a green indicator in surface mode, but a yellow one in dive mode, and you
can check this by starting a dive simulation.
