Rev: 01.20.22
Page 8
CCD-0004551
Operation
With Touch Controller
1.
Remove the boot from the bimini top.
2.
Turn on electrical power to the boat.
Only open the bimini top indoors when testing for proper installation. Opening the bimini top
outdoors subjects the system to possible strong winds that could result in severe product damage.
Only open the bimini top indoors when testing product for proper operation.
Do NOT fully open the bimini frame without the canvas top installed when testing product for
proper operation. Opening the bimini frame without the canvas top installed will result in severe
product damage. Only fully open the bimini frame with the canvas top installed.
3.
Use the Touch Controller or Bluetooth app to partially raise and lower the bimini top to ensure
proper installation.
Note:
Do
NOT
fully open the QC bimini system without the canvas top installed or failure of the system
will result.
Using the Touch Controller
The power bimini system is designed to shut itself off when full travel has been achieved. The system
will not open or close any farther once the system has achieved full travel until the opposite button has
been touched.
The Touch Controller uses touch-sensitive buttons (Fig. 6A), which do not require the mechanical motion
of depressing a button. Simply place, and keep, a finger on a touch control button to activate the system.
Removing the finger from a touch control button immediately stops the system; the bimini top remains in
the halted state (configuration) until a touch control button is touched again.
Operation
Indicator Light
A
Fig. 6
3.
Install the Nose Mount Caps into the ends of the actuators while aligning the cap's base with the top of
the boat railings (Fig. 5).
4.
Fasten the front of the Nose Mount Caps to the boat railings with the provided screws.
5.
Reinstall the previously removed (step 6) protective caps over the mounting screws.
