Lipco KSM 130, Original Instructions Manual

Page: 10 / 22

Instructions Compact disc mower KSM 130
10 - 22 140050-01-EN BA KSM 130 / 04.06.2020
7. Connection to the engine-driven machine
Before attaching the machine flange (Fig. 1, Ref. A) corresponding to
the type of engine-driven machine you have, it is recommended to
spread grease on the outer diameter of the machine hub (Fig. 1, Ref.
B). Then insert the flange with its two threaded pins (Fig. 1, Ref. C)
and the lock nuts. To attach the flange to the hub, proceed as follows:
•
Screw the threaded pins in as far as possible and then unscrew
them by one turn. Tighten the lock nuts. After this operation, make
sure that the flange oscillates freely without squeezing or blocking.
•
After having greased the connecting shaft (Fig. 1, Ref. D), insert it
on the machine shaft of the Compact Disc Mower. When these
steps are complete, move the engine-driven machine close to the
unit. Ensure the toothed wheel work of the connecting shaft
engages correctly with the power takeoff shaft of the engine-
driven machine and the flange has a centered contact with the
engine-driven machine. Then secure the connection between the
engine-driven machine and the unit.
•
Before commencing work, the drive flange must be lubricated.
(Fig. 1, Ref. E)
Fig. 1
B E