LION INTOXILYZER 8000, Operator'S Manual

Page: 12 / 57

O
REGON
S
TATE
P
OLICE
I
MPLIED
C
ONSENT
P
ROGRAM
I
NTOXILYZER
®
8000 O
PERATOR
’
S
G
UIDE
2.0 S
TEP
O
NE
– P
REPARING TO
C
ONDUCT A
T
EST
Originally Adopted: 07/13/2006
Revision #: 1.1
Revision Effective Date: 09/08/2006
the card. The operator will have approximately 30 seconds to complete the scanning process or the
instrument will default to manual entry and display the
“Enter Permit #” message. The instrument will
acknowledge that a successful scan of the operator’s card was completed by alerting the operator
with an audible tone. The instrument will then proceed to the
“Enter Operator PIN” message (see
Entering an Operator PIN ).
Entering Permit Data Manually
From the “Scan Operator Permit or Press Enter” message, the operator may choose to enter their
operator permit information manually by pressing the “Enter” key on the instrument’s keyboard. An
operator may choose to do this in the event that they have forgotten or lost their operator permit card,
or in the event that the bar code printed on the operator permit card is unreadable by the instrument’s
bar code scanner. The instrument will acknowledge the operator’s selection to manually enter permit
information by proceeding to the
“Enter Permit #” message.
Enter Permit #
The operator should type in his or her operator permit number (DPSST number). As the operator
enters information on the keyboard, the information will be displayed on the second line of the
instrument’s display. The operator must then confirm the permit information by pressing the “Enter”
key on the instrument’s keyboard.
IN ORDER TO START THE TESTING SEQUENCE, A VALID
OPERATOR PERMIT NUMBER AND PIN COMBINATION MUST BE ENTERED. THE OPERATOR
CANNOT CHOOSE TO SKIP THESE STEPS.
Following entry of the operator permit number, the
instrument will proceed to the “Enter Operator Name (Last, First, M)” message. If no permit number
is entered, the instrument will return to the “Ready to Start” message after approximately 60
seconds have elapsed. The instrument will abort the testing sequence if an invalid permit number and
PIN combination are entered. The
“Enter Operator Name (Last, First, M)” message will look similar
to the following:
Enter Operator Name
(Last, First, M)
The operator should type his or her name just as it is to be printed on the final Completed Test
Report. As the operator enters information on the keyboard, the information will be displayed on the
second line of the instrument’s display. Generally, name information is entered in a uniform format
similar to that used by the LEDS (Law Enforcement Data System) reporting system (last name, first
ALL PRINTED COPIES ARE UNCONTROLLED AND MAY NOT BE COMPLETE Page 10 of 54