![background image](http://html1.mh-extra.com/html/linn/majik/majik_service-manual_1925487019.webp)
Page 5.619
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
MAJIK: For Majik-IL after sn 2966 and Majik-IP after sn 3897. Majiks prior to these
serial number will require the main board to be changed. Contact Linn Service (or
your Linn Distributor) for further details.
WAKONDA: All Wakonda pre-amplifiers can have the RCU fitted.
Before starting, you must ensure that you have a clean workbench and take the
necessary anti-static precautions.
Always wear an anti-static wrist strap. Refer to the Service Manual (5.8) for full
details of the necessary working practices.
Note: This procedure is the same for the MAJIK or the WAKONDA.
Always disconnect the MAJIK/WAKONDA from everything, ESPECIALLY MAINS,
before fitting a RCU.
Parts required:
RCU/s (and fitting kit)
Unpack and check the contents of your RCU/S
Tools required:
No.1 Pozidrive screwdriver
Small Pliers
Unplug the LED wire and the
control board ribbon cable,
then remove the facia.
PROCEDURE:
1.
On a clean bench, and with a protective pad to protect
the facia, turn the MAJIK upside down, remove the
four screws and slide off the outer sleeve.Stand the
Majik on its facia. Remove the 4 screws and slip the
case off.
2.
Remove the four facia securing screws.
3.
With the facia face down, remove the 4
control board screws.
Break the four plastic securing legs andclips
off the display window.
Remove the four interim plate retaining screws,
then remove the window/button assembly from
the facia.
INSTALLING THE KNEKT RCU/S CONTROL PANEL