Page 5.616
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
INSTALLING SNEAKY KUDOS MODULE IN THE MAJIK / WAKONDA
P
HOTO
7
P
HOTO
8
21.
Disable the sleep function of the
MAJIK/WAKONDA display by
fitting a link (CONN 421) to pins 3
on P11 connector. This passes
the “sleep” control over to the
Kudos board and MUST be fitted.
(See photo 7)
Previous board revisions will be
different, find the pins and fit the
link across the pins marked
DISPLAY ON.
Please note: It is not possible to
Configure the display to remain
on the time when the Sneaky
Kudos is fitted.
22.
Re-fit the outer sleeve to the MAJIK/WAKONDA using the four screws
underneath which were removed previously.
23.
Power the product up and check that all is working and fully functioning.
Remove the protective tape from the front window. Installation is complete.
Please note: The Kudos Sneaky is selected by using any of the following:
Any of the top row of buttons on the Majik front panel
on the large Linn hand set
on the KUDOS hand set (when available)
on the Majik hand set (steps up and down through
presets only)
The Tuner input on the Majik is not affected and can be used as an
auxiliary input, by selecting tuner. For further details refer to the Owners
Manual.
24.
You should have the following parts left over from the MAJIK / WAKONDA
which should be retained in case of future removal of the KUDOS :-
MAJIK / WAKONDA control board
Sneaky slot blanking plate
Control area mounting plate
Rubber switch membrane
Six buttons
Display legends label
The Display window should be discarded as the mounting legs have been
broken off.
Configure for USA
If the Kudos is to be used in the USA it must be configured differently.
Fit 3 shorting links (supplied) to the
two-pin connectors at locations:
LK4 (middle one)
LK2
LK1
ZONE
WHERE
&
TUNE
%