Page 5.613
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
INSTALLING SNEAKY KUDOS MODULE IN THE MAJIK / WAKONDA
S
TAND
-
OFFS
E
XTENSION
SOCKET
INSTALLING SNEAKY KUDOS
1. Unpack and check the contents of your KUDOS Sneaky upgrade kit.
(See contents list in box.)
Tools required:
No.1 Pozidrive screwdriver
Small Pliers
Digital Multimeter
Before starting, you must ensure that you have a clean workbench
and take the necessary anti-static precautions. Always wear an
anti-static wrist strap. Refer to the Service Manual (5.8) for full
details of the necessary working practices.
Always disconnect the MAJIK/WAKONDA from everything,
ESPECIALLY MAINS, before fitting a SNEAKY module.
2.
On a clean bench, and with a protective pad to protect the facia, turn the MAJIK /
WAKONDA upside down, remove the four screws and slide off
the outer sleeve.
3.
With the MAJIK / WAKONDA sitting
on its feet again, remove the two
screws on the back-panel, and take
off the Sneaky slot blanking plate.
4.
Push-fit the two white plastic stand-
offs into the holes in the MAJIK /
WAKONDA main PCB until they
audibly ‘click’ and lock into position.
(See photo 1)
5.
Push the extension connector into the holes on the
underside of the KUDOS tuner PCB. (See photo 2)
It is important to fit this connector first to the KUDOS
tuner PCB, and not to the MAJIK / WAKONDA main
PCB, otherwise the pins may be damaged on assem-
bly.
Time required:
45 min, approx.
É
É
E
XTENSION
C
ONNECTOR
P
HOTO
2
P
HOTO
1