17
OPERATION FROM REMOTE CONTROL HANDSET The
TUNE
,
SCAN
,
PRESET
,
STORE
,
[ + ]
,
[ – ],
SIGNAL
and
MONO
buttons on the handset are
identical in operation to those on the front panel. In addition to these buttons, the
handset provides a numeric keypad, 0 - 9. This can be used to enter directly the tuning
frequency or the preset memory number.
DIRECT ENTRY OF TUNING FREQUENCY To enter the frequency, first press the
TUNE
button. Press the keypad buttons to enter the desired frequency. After the first
digit has been entered, the display shows three or four dashes ( – ) to indicate how
many more digits must be entered. When the complete frequency has been keyed in,
the display flashes to show that the frequency has been accepted. The tuner then
mutes while it tunes to the new station.
If the first digit entered is not within the valid tuning range of the KREMLIN, the display
shows four dashes ( - - - - ) and then reverts to the original frequency. After the first valid
digit, if subsequent entries would result in a frequency outside the tuning range, each
digit entry is changed automatically to result in a valid frequency.
If an error is made in keying in the frequency, press the
TUNE
button to clear the entry,
then either re-enter the correct digits or press
TUNE
again to return to the original
frequency.
DIRECT ENTRY OF PRESET NUMBER To enter the preset memory number, first
press the
PRESET
button. To select preset numbers from 1 to 9, briefly press the
buttons
1
to
9
on the handset. For preset numbers 10 to 80, press and hold the
button for the first digit until a dash ( – ) appears in the display (and the audio is muted),
then press the button for the second digit. If the selected preset memory is empty the
display shows E for a short time.
To store the tuned frequency in a preset memory, first press the
STORE
button. Enter
the preset number as described above, then press
STORE
again.
RF INPUT SELECTION Press the
0
button to switch between the
AERIAL
and
CABLE
inputs.