14
To select either the aerial or the cable input, press the
AERIAL
button (or the 0 button
on the remote control handset). When the aerial is selected, the display shows the
legend AERIAL.
To show the tuned frequency, press the
TUNE
button. The display shows the legend
MHz and the frequency as a four or five digit number.
To tune up or down the band, press the
[ + ]
or
[ – ]
button. A single press on the
button alters the frequency in 10KHz intervals. Holding the button pressed causes the
tuning to change continuously with the tuning rate gradually increasing. When a station
is detected, the tuning speed is reduced so that the programme may be heard. The
tuning indicator has two arrows and one square symbol. When off-tune the arrows
indicate the direction of tuning required to fine-tune the station. When on-tune, the
square symbol is shown brightly and the two arrows are dimmed.
To select scan tuning, press the
SCAN
button. The display shows SCAN.
To scan up or down the band, press C or 0 respectively. The display changes to show
the frequency (in MHz) counting up or down and one of the tuning indicator arrows is lit
to show the direction of scanning. During scanning, the audio is muted.
When a station is detected, the display stops counting, showing the frequency of the
station, and the audio is un-muted. If the
[ + ]
or
[ – ]
button is still pressed, the scan
direction arrow flashes and after five seconds scanning continues. Otherwise
scanning stops and after a short time the display reverts to SCAN. The scan direction
arrow is shown as a reminder of the previous scanning direction.
The operation of the scan function can be changed (see user selectable options) so
that as each station is found, it is played for five seconds, then scanning resumes
automatically. During the five second audition period the scan direction arrow flashes.
When the desired station is found stop the scanning by pressing the
SCAN
button.
Scanning can be stopped at any lime by pressing
SCAN
.
AERIAL
TUNE
SCAN