25
4-4. Other Setting
You can set various settings according to your usage.
For more details refer to [ XPort User Guide (XPort_UG.pdf) ] in the CD-ROM.
Pack Control
The packing algorithms define how and when packets are sent to the network.
Select [ Channel 1 ] -->[ Serial Settings ] and check [ Pack Control ]--> [ Enable Packing ]
to control the received data as you define.
e.g.)
Packets are sent to the network, when no serial data is received for 12
msecs or received 2bytes of CRC data after received 0x03
Idle Gap Time
: 12msec
Match 2 Byte Sequence
: No
Match Bytes
: 0x03,0x00
Send Frame Immediate
: No
Send Trailing Bytes
: Two
If the packet size reaches to the Maximum Transmission Unit (MTU)
(default 1400 bytes), a transmission might occur even if the packets are
not satisfy the condition.
Disconnect TCP
Select [ Channel 1 ] -> [ Connection ] and set [ Disconnect Mode ] to setup the condition of
disconecct TCP by the serial non-communication time.
e.g.)
Disconnect TCP when more than 30 sec of non-communication time.
On Mdm_Ctrl_InDrop
: No
Check EOT(Ctrl-D)
: No
Hard Disconnect
: Yes
Inactivity Timeout
: 0:30(mins:secs)
TCP Keepalive
Select [ Server ]. Set [ TCP Keepalive (secs) ]1 to 65(sec).
No TCP keepalive packet will be send, if you set 0.
Check the connection status by sending the TCP packet for checking.
Restore default XPort settings
Select [ Apply Defaults ] of Main menu to initial (factory default) all setup, except network
address (such as IP address etc.) and I/O pin.
[7-2. Factory Setting]
