5. Press and hold the Car2U
威
system button you would like to use
to control the garage door.
Immediately (within 1 second)
release the button once the garage
door moves. During this time the
selected button indicator light will
blink slowly. Do not release the
button until you see the garage door move. Most garage doors open
quickly. You may need to hold the button from 5–55 seconds before
observing movement of the garage door.
6. The indicator light will (begin to) blink rapidly until programming is
complete. If your garage door opener does not operate following these
steps, repeat Steps 2 through 6. Otherwise, call the toll-free Car2U
威
help
line at 1-866-57Car2U (1-866-572-2728).
After successful programming, you will be able to operate your Car2U
威
system by pressing the button you programmed to activate the opener.
The indicator light above the selected button will turn on to confirm that
the Car2U
威
system is responding to the button command.
Erasing the Car2U
姞
Home Automation System buttons
Note:
The system allows for three devices to be programmed. If you
need to change or replace any of the three devices after it has been
initially programmed, it will be necessary to erase the current settings
using the procedure below and then reprogramming all of the devices
being used.
To erase programming on the Car2U
威
system (individual buttons cannot
be erased), use the following procedure:
1. Firmly press the two outside
Car2U
威
system buttons
simultaneously for approximately
20 seconds until the indicator lights
begin to blink rapidly. The indicator
lights are located directly above the
buttons.
2. Once the indicator lights begin to
blink, release your fingers from the
buttons. The codes for all buttons
are erased.
If you sell your vehicle equipped with the Car2U
威
system, it is
recommended that you erase the programming for security reasons.
Driver Controls
87
2011 MKZ
(378)
Owners Guide, 1st Printing
USA
(fus)
