U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLink
威
at:
www.homelink.com
or
1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLink
威
equipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelink
威
buttons be erased for security purposes, refer to
Programming
in this section.
Programming
Do not program HomeLink
威
with the vehicle parked in the garage.
Note:
Your vehicle may require the ignition switch to be turned to the
ACC position for programming and/or operation of the HomeLink
威
. It is
also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink
威
for quicker
training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons releasing only when the
indicator light begins to flash after
20 seconds.
Do not
repeat Step 1
to program additional hand-held
transmitters to the remaining two
HomeLink
威
buttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink
威
.
2. Position the end of your
hand-held transmitter 1–3 inches (2–8 cm) away from the HomeLink
威
button you wish to program (located on your visor) while keeping the
indicator light in view.
3. Simultaneously press and hold
both the HomeLink
威
and hand-held
transmitter button.
Do not release
the buttons until Step 4 has
been completed.
Some entry gates and garage door
openers may require you to replace
Step 3 with procedures noted in the
“Gate Operator and Canadian Programming” in this section for Canadian
residents.
2006 Lincoln LS
(dew)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
121
Summary of Contents for 2006 LS
Page 320: ...320 ...