Lincoln Foodservice 10003032, Operator'S Manual

Page: 26 / 48

Tandem Operator Manual 26
FINGER ASSEMBLY INSTRUCTIONS
1. Before installing the retaining brackets in
the oven(s), be sure all of the packing
material is removed from the plenum
shroud. Install the finger retaining
brackets by placing them upside down
and hooking the retaining pin as shown
above.
2. Rotate the finger brackets until the
notches in the brackets sit on the
retaining pins.
3. Assemble fingers as shown in
steps 4 and 5.
7. Install finger in the oven by sliding it
over the plenum flange and setting
the front bracket. BE SURE THAT
THE FINGER SETS SQUARELY
OVER THE PLENUM FLANGES
AND THE HOLES POINT IN THE
PROPER DIRECTION. Top fingers
point down, bottom fingers point up.
8. Repeat step 7 until all sixteen (16)
fingers are installed.
Install conveyor and crumb pans
before operation. See “Conveyor
Reassembly” section for conveyor
installation instructions.
5. Install cover by sliding it on the
small end.
6. Insert assembled finger through
door opening starting with lower
left. NOTE: Install fingers
according to customer finger
arrangement specification.
4. Insert columnating plate so the
step goes under the lip of the
finger housing and the plate lies
flush with the housing side edge.