A-11
INSTALLATION
MODULAR FUME HOOD
™
MODULAR FUME HOOD XL;
TRIPLE COMPARTMENT:
For triple compartment hoods, do not make
cut-outs on both corners of the “A-TOP” and
“C-BOTTOM END” panels. Review the “A-TOP”
and “C-BOTTOM END” panel lay-out and cut
only on the required corners. Corner cutting is not required
for the panel assembled adjacent to the T-brackets.
a) Follow steps 1 to 3 as per single compartment
In case of Modular Fume Hood XL/standing:
Mount connection plates (2 plates on each on all four corners) of
corner reinforcement set on the main profiles using self-tapping
screws. See Figure A.15.
b) Mount two T-brackets on the main frame profile. See Figure
A.16.
c) Determine the ideal position of the T-brackets by means of
the long H-profiles to be used between the roof panels.
d) Mount two cross profiles on each T-bracket. See Figure A.17.
e) Place the other T-bracket(s) on the loose side of cross-profiles
to keep them together. Do not fasten the screws yet. See
Figure A.17.
f)
Make sure the cross-profiles are precisely square (90°) to the
main frame profile. See Figure A.17.
g) Finish the entire compartment (except for the last “A-TOP”
roof panel) before continuing with the next compartment. See
Figure A.17 and Figure A.12. Follow steps 4 to 18 as per
single compartment
h) Use a cargo lashing (1) around the end of the profiles to keep
them in the right position.
i)
Fasten the T-bracket(s) to the cross profiles and the main
frame profile.
j)
Follow steps 19 and 20 as per single compartment
FIGURE – A.16
FIGURE – A.17
Fig. VIII
90°
90°
XL
1
XL
10 mm
T-BRACKET
ATTENTION
