A-7
INSTALLATION
MODULAR FUME HOOD
™
Carefully read and follow the instructions before
proceeding to make any cut-outs on the panels.
To mount the Modular Fume Hood proceed as fol-
lows:
SINGLE COMPARTMENT
In case of making a double or triple compartment hood,
carefully read through the respective sections before
proceeding to the below steps
1. Form a U-shape using 3 main frame profiles and 2 outside
corner pieces. See Figure A.2.
FIGURE – A.2
2. Slide the main frame profiles halfway over the outside corner
pieces. See Figure A.3.
FIGURE – A.3
3. Place the inside corner pieces (1) and slide in the main frame
profiles (2). Fasten the corner piece (3) to the main frame
profiles with self-tapping screws. Use inside corner pieces as
template. See Figure A.4.
FIGURE – A.4
Refer to “A-TOP”, “B-BOTTOM” and “C-BOTTOM
END” markings on the panels for easy identi-
fication and assembly.
Remove protection foil from roof panels before assembly.
Panel identification markings are on the foil and make sure
not to remove the foils at one time from all panels, this may
lead to difficulties with assembly.
4. Make cutouts in the “A-TOP” roof panels that will be mounted
in the corners. See Figure A.5.
For double and triple compartment hoods, do not
make cut-outs on both corners of the “A-TOP”
panel. Review the “A-TOP” panel lay-out and cut
only on the required corners. Corner cutting is not required
for the “A-TOP” panel assembled adjacent to the T
-brackets.
FIGURE – A.5
90°
90°
1
2
2
3
10 mm
A
B
B
A
mm
inch
A
45
1.8
B
10
0.4
ATTENTION
ATTENTION
ATTENTION
