Lincoln Electric K14110-1, Operator'S Manual, Page: 9 / 35

English English 6
Figure 3
14. Lighting Switch
15. Cold Inch / Gas Purge Switch: This switch enables
wire feeding or gas flow without turning on output
voltage.
16. Gun Mode Switch:
changes the function of the gun’s
trigger.

2 Step trigger operation turns welding on and off
in direct response to the trigger. Welding process
is p
erformed when the gun’s trigger is pulled.

4-Step mode allows to continue welding, when
the gun’s trigger is released. To stop welding, the
gun’s trigger is pulled again. 4-step mode
facilitates to making long welds.
The functionality of 2T/4T mode is shown in the Figure 4.
Trigger pressed
Trigger released
A Welding current
B Burnback Time (fixed)
C Wire Feed
G Gas
Figure 4
Note:
4-Step does not work during Spot Welding.
17. Wire Spool Support: Maximum 15kg spools. Accepts
plastic, steel and fiber spools onto 51mm spindle.
Also accepts Readi-Reel
®
type spools onto included
spindle adapter.
18. Wire Drive: 4-Roll wire drive.
WARNING
The wire drive door has to be completely closed during
welding.
WARNING
Not use handle to move the machine during work. See
"Accessories" chapter.
User Panel
Figure 5
19. Display:

Left display: Shows wire feed speed or welding
current. During welding shows the actual
welding current value.

Right display: Depending on the source
welding and the welding program shows the
welding voltage in volts units or Trim. During
welding shows the actual welding voltage
value.
20. Status LED: A two color light that indicates system
errors. Normal operation is steady green light. Error
conditions are indicated, per Table 1.
Note: The status light will flash green, and sometimes
red and green, for up to one minute when the machine is
first turned on. When the power source is powered it can
take as long as 60 seconds for the machine to be ready
to weld. This is a normal situation as the machine goes
through initialization.
34
33
32
31
30 29 28 27
26
25
24
23
22
19 21 20 19