Lincoln Electric ESSENTIAL OXYCUTTING, Safety Instruction For Use And Maintenance

Page: 21 / 42

8695 4985 / C
ESSENTIAL OXYCUTTING
D-17
D - MONTAGE INSTALLATION
1 - CONDITIONS OF INSTALLATION
Also see the conditions for installing the machine and options in the associated documentation.
THE FOLLOWING CONDITIONS MUST BE COMPLIED
WITH BEFORE INSTALLING THE EQUIPMENT
1.1 FLUIDS POWER SUPPLY
Provide the gas sources (cylinders, cylinder racks, evaporators etc.) below, each fitted with a regulator that can
provide the recommended output and pressure values and a stop valve in case of arrival by pipe. Do not install
gases other than those defined in this manual (risk of leaks).
Never exceed the maximum pressure specified for the supply to
the installation
Starting up the gas sources
Please refer to the section:
"CYLINDER CHANGE PROCEDURE"
of the safety booklet 8695 7050
If the sensing option is present, see the specifications for compressed air in the document 8695 4987 "Essential
Sensing Option"
The customer must supply and install a device for isolating each source of
energy (electricity, air, gas and water). The devices must be clearly identified.
They must be of the locking type, with three ways if possible as regards gas.