2
MAINTENANCE INSTRUCTIONS
WALKING BELT CENTERING AND TENSION ADJUSTMENT
The walking belt may occasionally need to be centered and tightened.
TO ADJUST WALING BELT TENSION:
● Run treadmill at approximately 3.5 mph.
● Using Allen wrench, turn both the right and left
adjustment bolts ONE full turn clockwise.
● If slipping continues during use, repeat above steps
NOTE: It is recommended that the allen wrench clip
be attached to a convenient spot on the treadmill.
And the allen wrench kept in the clip.
DO NOT OVERTIGHTEN the walking belt.
This may
cause reduced motor performance and excessive roller
wear.
NOTE:
When properly tightened, the sides of belt can
be raised approximate 2-3 inches off the board.
TO CENTER WALKING BELT:
● Place treadmill on a level surface.
● Run treadmill at approximately 3.5 mph.
● If the belt has drifted to the right, turn the right adjusting bolt 1/2 turn clockwise and the left adjusting bolt
1/2 turn counterclockwise
● If the belt has drifted to the left, turn the left adjusting bolt 1/2 turn clockwise and the right adjusting bolt
1/2 turn clockwise and the right adjusting bolt 1/2 turn counterclockwise
Picture A: If the belts has drifted to the LEFT
Picture B: If the belts has drifted to the RIGHT
Summary of Contents for D15.0
Page 1: ... 0 OWNER S MANUAL ...
Page 27: ...4 EXPLODED DRAWING ...
