Lime D15.0, Owner'S Manual

Page: 23 / 30

0
TROUBLESHOOTING GUIDE:
TROUBLESHOOTING GUIDE
PROBLEM
CAUSE CHECKING CORRECTION
1. The plug and the line is
loosen.
1. Checking the plug and
the line is connected well.
1. Insert the plug and the line well.
Treadmill
will not
start.
2. Not plugged in.
2. Checking the power
switch is opened.
2. Reset the power.
1. The relative line of the
control motor are abnormal.
1. Checking the line of the
control motor is plugged
well.
1. Insert the control motor wire.
2.Do not press START KEY.
2. Checking the button is
valid or not started the
switch.
2. Reset the START KEY to test.
3. Safety pull pin not
inserted
3. Checking the safety pull
pin is plugged well.
3. Insert safety pull pin.
4. Motor plug is loosen or
the motor is badness.
4. Testing if the motor is
badness.
4. Change the motor
The motor
will not
work.
5. Power or controllar
specification is wrong. AC
110 / 230 V.
5. Checking the
specification.
5. To choose the correct
specification to reset the testing.
1. Checking the distance
and place between
SENSOR and magnet.
1. Adjust the distance within
5 m/m.
2. Checking the wire if
circuit breaker tripped.
2. Change the wire or SENSOR
No speed
SENSOR do not touch well.
3. Checking the wire tie-in
if it is touched well.
3. Reset to insert the wire tie-in.
PA circuit
board
PA circuit board bolt do not
lock well or not put well the
connector.
Take apart the bottom
cover and press PA circuit
board to see if it is short
circuit or loosen.
Reset to put the connector and
lock the bolt.
No hand
pulse
SENSOR do not touch well.
1. Checking the wire is
short circuit or lossen.
1. Change the wire or reset.