Drill a 3/32" (2.4mm) hole at the center of the chosen
area.
Use a pencil and a compass to mark a circle 3.6"~4.1"
(90~105mm) in diameter and cut the circle.
Embedded Mounting (False Ceiling)
Step 1. Ceiling Preparation
Note: Due to camera body cable tap hole position, drill hole bigger than 3.6"(90mm) but smaller than fix ring inner diameter.
Step 4. Control Cable Connection
Connect RS-485 cable.
Step 3. Camera Setting
RS-485 Protocol
Switch
12345678
ON
12345678
ON
Camera System
& ID Switch
Separate rubber sheet from the camera main body.
Set Panorama Camera ID, RS-485 Protocol and Camera
system.
Step 2. The Ceiling Ring
105mm
90
°
Place fixed ring on the
ceiling.
Fixed ring size and screw
location.
Tighten the four tapping
screws into the ceiling or
four machine screws with
four screw nuts.
125mm
125mm
Note: Refer to
section P2~4
TXDI+ TXDI
-
TXDO+ TXDO
-
GND
Connect DC12V Power
cable. (Suggest to use the
ADAPTOR from the factory.)
Connect four video signal
cable. [4CH BNC Model]
6
Connect RJ-45 cable.
[CAT5 Model]
