Connect DC12V Power
cable. (Suggest to use the
ADAPTOR from the factory.)
Step 4. Control Cable Connection
Connect RS-485 cable.
Step 3. Camera Setting
TXDI+ TXDI
-
TXDO+ TXDO
-
GND
Connect RJ-45 cable.
[CAT5 Model]
8
Step 5. Install Camera Body and Ring
RS-485 Protocol
Switch
12345678
ON
12345678
ON
Camera System
& ID Switch
Separate rubber sheet from camera main body.
Set Panorama Camera ID, RS-485 Protocol and Camera
system.
Note: Refer to
section P2~4
Step 6. Install Decorative Ring
Rotate the decorative ring
counter clockwise until its
position column touch the
camera body positioning
column. Tighten the 4
screws.
Put the decorative ring on
the camera body.
Ring’s positioning
column should be between
camera body positioning
column and screw nut.
Notice:
Installation is complete.
Attach the camera body to
the fixed ring.
Camera body screw
hole should be align to fixed
ring’s latch position..
Notice:
Tighten the two screws to
fix the camera body.
