To install the DRIVECOD unit properly please read carefully and follow the
instructions below; note anyway that the unit can be installed in several
manners and according to the specific user's application.
•
If required, mount an adapting flange
1
; the adapting flange
1
can be either
fixed to the actuator's flange
2
first and then to the planetary gearbox
4
; or
on the contrary it can be fixed to the planetary gearbox
4
first and then to
the actuator's flange
2
,
according to the
mounting configuration;
•
use M5 type screws
3
to
fix the adapting flange
1
to the actuator's flange
2
;
•
use the screws
5
to fix the
planetary gearbox
4
to
the adapting flange
1
;
•
couple and fasten the
actuator and the
planetary gearbox
4
together using the screws
3
or
5
according to the
mounting configuration;
properly secure the shaft
of the actuator and the
shaft of the planetary
gearbox
4
;
•
it could be advisable to install a coupling between the actuator and the
planetary gearbox
4
;
•
mount the shaft of the planetary gearbox
4
on the drive's shaft and properly
secure them together; then fasten the planetary gearbox
4
to the flange or
the mounting support
6
by means of the screws
7
.
WARNING
Never force manually the rotation of the shaft not to cause permanent
damages! The counter-electromotive force (back EMF) generated by the motor
in case the shaft is forced to spin due to a manual external force may cause
irreparable damages to the internal circuitry.
MAN RD6 MB E 1.1
Mechanical installation
14 of 92
RD6 Modbus®
